Round-the-Clock Emergency Response
What happens in the first few hours shapes the whole job. Water wicks up gypsum, swells particleboard underlayment, and fills carpet pad quicker than people expect. Inside a day or two, a clean-water leak can become a mold problem. For that reason, the line never closes overnight and emergency calls go straight to the nearest contractor who is on call.
An emergency visit normally begins with the crew confirming the source is off and the space is safe. They confirm the water is shut off, check whether electrical circuits near the water need to be killed at the panel, and then start extraction with portable or truck-mounted units. When there is standing water below grade, a submersible trash pump usually goes in before anything else. Next comes a round of moisture readings, a thermal imaging pass to map where water spread, and the initial set of air movers and LGR dehumidifiers.
By the end of the first visit, you should know a few things clearly. You should know which areas are wet, the water category, and which materials stay and which ones go. You should also know when the crew is coming back to take readings and move equipment. Three to five days of drying is typical, but hardwood floors, plaster walls, and stone foundations can stretch that out. Leave the equipment running, keep windows shut unless told otherwise, and keep the thermostat where the crew set it.
- Burst pipes, broken supply lines, and leaking water heaters
- Storm water, roof leaks, and window well flooding
- Failed sump pumps and seeping basement walls
- Nights, weekends, and holidays handled the same way




